Step 2. Set Up A Frame Relay Routing Service - Alcatel Omni Switch/Router User Manual

Configuring a WAN Routing Service

Step 2. Set Up a Frame Relay Routing Service

You create a Frame Relay routing service using the
set up a routing service.
1. Enter the
the service number for the routing service:
A screen similar to the following displays:
You make changes to the options in this screen at the colon prompt (:). You make
changes by entering the line number for the option you want to change, an equal sign
(=), and then the value for the new parameter.
2. Enter a description of this routing service by entering 1, an equal sign (=), and then a
description for this service. Your description can be up to 30 characters long.
When you are done entering a description, press
3. Specify that this is a routing service by entering a 2, an equal sign, and an
This specifies that you want to set up a routing service, as opposed to a Trunking or
Bridging service. Press
4. By default, the routing service is Enabled. This means that as soon as you are done
configuring the service, it will begin routing Frame Relay traffic. If you would like to
disable this routing service now and enable it later, enter
5. You need to specify the
Multiple VCs may be configured for a single routing service and all configured VCs will
map to a single virtual router port. Enter a 4, an equal sign (=), and then the
numbers for each virtual circuit. Separate
below.
Press
Page 29-60
command followed the slot number, a slash (/), the port number, and then
.
s of the virtual circuits to include in this routing service.
DLCI
after you enter all virtual circuit
command. Follow the steps below to
.
and press
s with spaces, as shown in the example
DLCI
s.
DLCI
as follows:
.
DLCI