Alcatel Omni Switch/Router User Manual page 250

Configuring the HRE-X Router Port
For example, to assign register 3 to the Classical service enter
IP
at the system prompt. A screen similar to the following is displayed.
As indicated on the screen, the register assignment will not take effect until the switch is
rebooted. If you use the command after making a the register assignment shown
in the above example, a screen similar to the following is displayed.
This indicates that register 3 is assigned to the service but is actually using the Routing
CIP
service. Also, the message at the bottom of the table indicates that the HRE-X configuration
has changed since the last reboot of the switch. After a reboot, the command will
display the following screen.
Page 9-28