Selecting A Default Group; Using The + Or - To Change Groups - Alcatel Omni Switch/Router User Manual

Selecting a Default Group

Most commands in the Bridge Management Menu allow you to specify a group when
entering the command at the system prompt. If you do not specify a group when entering a
command, the bridge operations are performed on the currently selected group.
You can view the current groups in the switch by
entering
To select a group, enter the
where
to select Group 2 you would enter
A message confirming the selection of the new group ID followed by the group description.

Using the + or - to Change Groups

At any time from the system prompt, you can select a different group by typing a plus ( ) to
move up one group, or a minus ( ) to move back one group. For example, if you are
currently working on Group 4 and wish to change to Group 3, you would enter a at the
system prompt. The following message displays to confirm the change:
o Note o
at any prompt.
command as follows:
is the number of the group you wish to modify or view. For example,
and the number
Selecting a Default Group
as shown:
Page 17-7