Enabling Bootp/Dhcp Relay - Alcatel Omni Switch/Router User Manual

In this example, the
the DHCP server and associated clients. The
address will be allocated an
IP
This configuration works if you require only one
subnet. All clients received on the same router port will
be assigned to the same
Note that the client's request frames will also be received and forwarded by the
if it is configured.
The non- workstations will be assigned to
DHCP
These workstations already have manually configured
server to dynamically assign them an address. AutoTracker will move these workstations into
the s with network address policies (
VLAN IP
It is true that these non-
Network Address policies have precedence over
match on a Network Address policy, it does not look for a protocol policy match.

Enabling BOOTP/DHCP Relay

To enable relay for
UDP
At the prompt for the UDP Relay Configuration screen (the UDP Relay Configuration screen is
displayed using the
26-3), enter the following:
The screen redisplays with more configuration options for
The parameters are defined here.
Server Address
This parameter allows you to list, add, or delete the server address(es) to which the
relay will forward. The default is
DHCP
address, the value redisplays as
cannot be an internal DHCP server configured through the IP Control feature. For more infor-
mation about IP Control, see the Switched Network Solutions User Manual.
defined by an IP protocol policy is used as a mechanism to group
VLAN
DHCP
address on the same subnet.
IP
o Note o
VLAN
VLAN 10
workstations also match the
DHCP
:
BOOTP/DHCP
command described in UDP Relay Configuration Screen on page
. Up to 8 addresses may be configured. The server address
server is local, so all clients requesting an
DHCP
.
s defined by Network Address policies.
VLAN
addresses. They don't require a
IP
and ).
VLAN 20
protocol policy. However,
IP
protocol policies. If AutoTracker finds a
IP
BOOTP/DHCP
When you have configured at least one valid
BOOTP/DHCP Relay
relay
BOOTP
.
BOOTP/
Page 26-9