Configuring Secure Access Filter Points - Alcatel Omni Switch/Router User Manual

Configuring Secure Access Filter Points
The command allows you to view the list of secure access filter points, to enable/
disable security globally or for a specific IP protocol filter point, and to define a filter list for
each filter point. To use this command, enter:
A screen similar to the following displays:
If security is enabled for a filter point and there are no
names defined on its list, then the filter point is essen-
tially inaccessible to all users. For example, in the
above sample display,
user.
You can enter commands by entering just the first letter of the command. For example, select
by entering and pressing
provide reference and instructional information on using this command. The
this command without saving configuration changes. The
When you are done entering new values, type
saved.
The following option is available for all filter points:
Filter List
Applies the filter name(s) defined through the
Filter points are disabled by default. The different filter points are defined as follows:
o Note o
is not accessible to any
SNMP
.The question mark option ( ) and the
at the prompt and all new settings will be
command for this filter point.
Secure Switch Access
option
option exits
option refreshes the screen.
Page 8-7