Wsx-S-2W; Wsx-S-2W Technical Specifications - Alcatel Omni Switch/Router User Manual

WSX-S-2W

The supports two (2) serial ports, which can provide access rates from 9.6 Kbps to
WSX-S-2W
2 Mbps. The
WSX-S-2W
WSX-S-2W Technical Specifications on page 3-27 for more information.
The
sion.
The can sense and auto-configure for any of five serial cable types (
WSX-S-2W
, , and
X.21 RS-530 RS-449
can be turned into a physical
cable. The
DCE WSX-S-2W
Software in the switch allows you to configure parameters for the Frame Relay or Point-to-
Point Protocol ( ). Software commands allow you to view the status of the
PPP
tion at the
WSX-S-2W
each level. Software commands for Frame Relay are described in Chapter 29, "Managing
Frame Relay"; commands for
With the optional
HRE-X
second per module and up to 12 Mpps in a fully-loaded 9-slot chassis.
Number of ports
Connector Type
Protocols Supported
Data Rates Supported
Clocking
Virtual Circuits Supported
MAC Addresses Supported
Connections Supported
Cable Supported
Power Consumption
also supports three types of clocking (internal, external, and split). See
o Note o
does not support hardware compres-
WSX-S-2W
). A port is normally considered a physical
WSX-S-2W
device—for speed or clocking purposes— by plugging in a
DCE
senses whether a
DCE
board, port, or virtual circuit level. Extensive statistics are provided at
are described in Chapter 30, "Point to Point Protocol."
PPP
you can increase routing performance to 1.5 million packets per
WSX-S-2W Technical Specifications
2
High-density 26-pin shielded serial
Frame Relay and Point-to-Point (PPP)
9.6, 19.2, 56, 64, 128, 256, 512,
768, 1024, 1536, 2048 Kbps
Internal, External, or Split
Permanent Virtual Circuits (PVCs)
4,096
Physical Data Terminal Equipment (DTE) or
Data Communication Equipment (DCE)
DTE or DCE in the following types:
R2-232, V.35, X.21, RS-530, RS-449
5.25 amps (without an HRE-X)
6.75 amps (with an HRE-X)
or cable is connected.
DTE
WAN Modules
, ,
RS-232 V.35
device. It
DTE
connec-
WAN
Page 3-27