Table of Contents
Advertisement
Setting Automatic Config Synchronization
The
command sets the automatic configuration synchronization to Enabled or
Disabled. If it is Enabled, then the
synchronization automatically. This means that when the configuration file (
updated in the primary
the two
in sync.
MPXs
Enabling Automatic Config Synchronization
To enable synchronization between the primary and secondary
at the system prompt. The following prompt will then be displayed if synchronization is not
enabled.
Press
to enable synchronization or enter
zation, the following will be displayed.
Note that automatic configuration synchronization is disabled unless all image (
Programmable Gate Array (
Image Files on page 6-16 for information on the
image and
files.
PGA
The interval between updates is 5 minutes. The primary
secondary
after 5 minutes have elapsed since the last update.
MPX
Disabling Automatic Config Synchronization
To disable synchronization between the primary and secondary
at the system prompt. The following prompt will then be displayed if synchronization is
enabled.
Press
to disable synchronization or enter
zation, the following will be displayed.
If automatic config synchronization is Disabled, the configuration file in the secondary
will be unaffected if you change the configuration file in the primary
primary/secondary pair will continue to maintain
MPX
, it will automatically be updated in the secondary
MPX
) files in the switch are synchronized first. See Synchronizing
PGA
Setting Automatic Config Synchronization
MPX
, enter
MPXs
to cancel. If you enabled synchroni-
command, which synchronizes
will copy any changes to the
MPX
, enter
MPXs
to cancel. If you disabled synchroni-
.
MPX
) is
, keeping
) and
MPX
Page 6-15
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
