Trunking - Alcatel Omni Switch/Router User Manual

Trunking

A trunking service must be set up for each virtual circuit that will support trunking. When
trunking is set up, you specify the slot, port,
over the virtual circuit.
The illustration below shows a sample trunking configuration. The
two trunk ports, one to Chicago and one to New York.
Trunk port attaches to
V C t o L o s A n g e l e s .
Groups 3 and 4 Trunked.
Trunk Ports and Virtual Circuits Over Frame Relay Network
Frame Relay virtual ports are mapped one-to-one to virtual circuits, so each of these trunk
ports is connected to a virtual circuit. When setting up Trunking you need to be aware of
your virtual circuit configurations, their
Trunking Service is described in Configuring a Trunking Service on page 29-62.
No standard exists for trunking Groups or
Frame Relay. Therefore, you must configure Trunking
using Alcatel's method.
, and Groups that are going to be trunked
DLCI
Trunk ports attach to VCs to Chicago
and New York. Trunk Port/VC to Chica-
go carries Groups 3 and 4. Trunk Port/
VC to New York carries Groups 2 and 3.
, and their termination points. Configuring a
DLCIs
Note
in Los Angeles has
WSX
Trunk port attaches to
V C t o L o s A n g e l e s .
Groups 2 and 3 Trunked.
over
VLANs
Page 29-19
Trunking