Table of Contents
Advertisement
Display Local Server Information
The
command is used to display information about the local switch's implementation
of
. To view local switch
NTP
prompt. A screen similar to the following is shown:
Field Descriptions
The following section explains the fields shown using the
The
address of the switch.
IP
. The peer mode of this remote association. There are five possible modes:
symmetric active, symmetric passive, client, server, and broadcast. The displayed mode is
assumed if this association becomes the switch's host
modes, see Display List of Peers the Server Knows About on page 12-15. For a description of
how to configure a peer, see Configuring a New Peer Association on page 12-12.
. The status of leap second insertion for this association. Leap seconds are
seconds that are added to the timestamp of an
The possible values are:
. The stratum level of the remote peer. If this number is
been synchronized.
. The advertised precision of the switch. It will be a number between -4 and -20.
. This is a signed fixed-point number indicating the total roundtrip delay to the
primary reference source at the root of the synchronization subnet, in seconds. Note that this
variable can take on both positive and negative values, depending on clock precision and
skew.
. This is a signed fixed-point number indicating the maximum error relative to
the primary reference source at the root of the synchronization subnet, in seconds. Only posi-
tive values are possible.
. This is a 32-bit code identifying the particular reference clock. In the case of
stratum 0 (unspecified) or stratum 1 (primary reference source), this is a four-octet, left-justi-
fied, zero-padded
ASCII
is the four-octet Internet address of the peer selected for synchronization.
information, enter the
NTP
NTP
No warning.
Last minute has 61 seconds.
Last minute has 59 seconds.
Alarm condition (clock not synchronized)
string. In the case of stratum 2 and greater (secondary reference) this
command at the system
command.
server. For a description of the
NTP
entity to correct accumulated time errors.
, the remote peer has not
NTP Information Menu
Page 12-21
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
