Adding Virtual Ports - Alcatel Omni Switch/Router User Manual

Adding Virtual Ports

Adding Virtual Ports
You can add virtual ports to a Group at any time after the Group is created. The
command allows you to add one or more ports to a Group you specify. If you have used the
command to add virtual ports, then you will find the
iar.
To use
the port. Next, specify the port or ports you want to add.
For example, if you wanted to add ports 4 through 6 on the module in slot 4 to Group #5,
then you would specify:
The procedure for using
1. Enter
by the physical slot and port numbers you want to configure.
2. If you enter a port that is already assigned to another Group, then you will be prompted
on whether or not you want to change its assignment. A message similar to the following
displays for each port that you enter:
Simply enter a
port parameters. You could also enter a
ters and skip port configuration questions. If you enter a , all remaining ports are auto-
matically added to the Group with default settings, and your work is complete.
3. The virtual port configuration menu displays:
Descriptions for each of the fields in this display begin on page 19-29. To change any
default value, enter the line number for the item, an equal sign (=), and then the value for
the parameter. When you have completed the configuration for this port, enter
save all configured settings.
Page 19-44
, enter the command followed by the Group number to which you want to add
is as follows:
followed by the Group number where you want this port to reside, followed
at each port prompt to change its Group assignment and begin setting
command fields very famil-
at this prompt to accept all default port parame-
to