Omni Switch/Router User Interface (Ui) Software; Omni Switch/Router Network Management Software (Nms) - Alcatel Omni Switch/Router User Manual

Currently, Omni Switch/Router switching modules consist of Gigabit Ethernet modules, auto-
sensing Ethernet modules, Fast 10/100 Ethernet modules, 10 Mbps Ethernet modules,
modules, and Voice Over IP (
Modules," for documentation.
Omni Switch/Router modules require the use of an
Omni Switch/Router chassis (see Omni Switch/Router
Chassis and Power Supplies on page 1-7). Do not
install an Omni Switch/Router module in an
OmniSwitch chassis and do not install an OmniSwitch
module in an Omni Switch/Router chassis.

Omni Switch/Router User Interface (UI) Software

Omni Switch/Router hardware uses the same User Interface (
Management Software (
broadcast management, multicast management, any-to-any switching, virtual
firewalls, user authentication,
In Release 4.4 and later, the Omni Switch/Router is
factory-configured to boot up in
Interface) mode, rather than in
mode. Chapter 4, "The User Interface," includes docu-
mentation on changing from

Omni Switch/Router Network Management Software (NMS)

You need Release 3.4, or higher, of Alcatel's X-Vision Network Management Software (
to operate with Omni Switch/Router hardware.
Page 1-2
) modules. See Chapter 3, "Omni Switch/Router Switching
VOIP
o Important Note o
) as OmniSwitch hardware. Omni Switch/Router modules support
NMS
access, and policy-based configuration.
WAN
o Important Note o
CLI
) commands and Network
UI
(Command Line
CLI
(User Interface)
UI
mode to mode.
UI
WAN
( ),
LANs VLANs
)
NMS