Table of Contents
Advertisement
NTP Information Menu
To view the
configuration menu, enter the
NTP
are using verbose mode, the
tion mark ( ) at the prompt to display this menu:
The main menu options are shown in the
change menus.
Display List of Peers the Server Knows About
The
command is used to display a brief list of all
switch (servers, peers, etc.).
To display a list of
NTP
display similar to the following is shown:
The list shows the mode this switch is using in relation to the association, and the address of
the remote association. The address is either a domain name or an
modes are as follows:
configuration menu is displayed. Otherwise, enter a ques-
NTP
associations, enter the
A host in this mode sends periodic messages regardless of the
reachability state of stratum of its peer. By operating in this
mode the host announces its willingness to synchronize and be
synchronized by the peer.
This type of association is ordinarily created upon the arrival of
a message from a peer operating in the symmetric active mode
and persists only as long as the peer is reachable and operat-
ing at a stratum level less than or equal to the host; otherwise
the association is dissolved. The association will always persist
until at least one message has been sent in reply. By operating
in this mode the host announces its willingness to synchronize
and be synchronized by the peer.
A host operating in this mode sends periodic messages regard-
less of the reachability state of stratum of its peer. By operating
in this mode the host, usually a
willingness to be synchronized, but not to synchronize the
peer.
command at the system prompt. If you
list for quick access if you need to
associations related to this
NTP
command at the system prompt. A
address. The available
IP
workstation, announces its
LAN
NTP Information Menu
Page 12-15
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
