Viewing Port Errors - Alcatel Omni Switch/Router User Manual

Viewing Port Errors

The command displays port error statistics for ports in the switch. Entering
displays error statistics for all virtual ports in the switch. You can also display errors statistics
for only ports in a specific Group by specifying the Group ID after the
example, to view errors only for ports in Group 6, you would enter
You can also display error statistics for a specific port by entering the slot and port number
after the command. For example, to view errors only for Port 1 on the module in Slot 4,
you would enter
The same type of information is displayed for a single Group or port as is displayed for all
ports in a switch. The following screen shows a sample from the
fied without any Group or port parameters.
These columns are described for the
The Service Type (
switch. Service Type values are as follows:
• Virtual router port
• Virtual bridge port
• Virtual trunk port (used for
•
802.10 FDDI
• Frame Relay trunk port
•
LAN
• VLAN clusters (X-LANE) service port
• Classical IP service port
) and Instance (
WAN
service port
Emulation service port
command when speci-
command on page 19-50.
) of this Service Type in the
)
Viewing Port Errors
command. For
Page 19-55