Installing Combo Port Sfps; Installing Backup Power Supply Components - Alcatel OS6850-48L Getting Started Manual

7
Once the screws at the bottom of each flange are
secure, install the remaining two rack mount screws. Be
sure that all screws are securely tightened.
8 If you are installing multiple switches in a rack to form
a stacked configuration, repeat steps 1 through 7 for all
switches in the stack.
Note. When rack mounting multiple switches in a stacked
configuration, be sure to place all switches in vertically-
adjacent rack positions. This will ensure that all required
stacking cables will have adequate length for the installa-
tion.

Installing Combo Port SFPs

OmniSwitch 6800 Series switches offer Gigabit Ethernet
combo ports, located on the front panel (see
54). These combo ports support hot-swappable fiber Small
Form-Factor Pluggables (SFPs). For instructions on installing
and removing combo port SFPs, refer to the instruction card
provided with the SFP product.
Note. Combo port preferences are user-configurable via
the system software. Refer to the "Configuring Ethernet
Ports" in the OmniSwitch 6800/6850/9000 Network
Configuration Guide for complete details.
14 Setting Up the Hardware
Installing Backup Power Supply
Components
For detailed information on installing backup power supply
components—including the backup power supply shelf, power
supply modules, chassis daughtercard, connector cables, and
power cords—refer to the OmniSwitch 6800 Series Hardware
Users Guide.
page 53 and page
Note. For further details regarding supported SFP and
XFP transceivers, refer to the OmniSwitch 6800 Series
Hardware Users Guide.
October 2006