Power On The Switch; Verify Leds; Omni Switch/Router Mpx; Omni Switch/Router Switching Modules - Alcatel OmniSwitch/Router Getting Started Manual

The Console Management ports are
to interface with switch software. One port, called the
"modem" port, is a male
called the "console" port, is a female
They are each 9-pin "D" (
conform to the
IBM AT
connecting device does not conform to the
serial port specification, you may need a special cable
or adapter.

7. Power On the Switch

Turn the power supply On/Off switch to the On (I)
position.

8. Verify LEDs

Check that s on the front panel of the chassis indi-
LED
cate a normal state of operation. On an
should be on steady Green if one power supply is
LED
inserted. If two power supplies are installed, both the
and should be on solid Green.
LEDs
PS1 PS2
8 Installing Your Switch
ports used
RS-232
connector and the other,
DTE
connector.
DTE
) connectors that
DB-9
serial port specification. If the
IBM AT
the
MPX,
All modules are subjected to extensive power-on diag-
nostics during the Power-On Self-Test cycle (
this reason, you should allow the switch several
seconds to perform preliminary tests before evaluating
the . While the diagnostics are running, the
LEDs
will blink Amber. When diagnostics are
OK2 LED
complete and all modules are operating correctly, the
on all modules should be on solid Green and
LED
OK1
the
LED
OK2
below summarize how
operation.

Omni Switch/Router MPX

LED
PS1
PS2
PS1
OK1
OK2

Omni Switch/Router Switching Modules

LED
OK1
OK2
should be blinking Green. The tables
s should display in normal
LED
Normal State Comments
Green If the corresponding power
On Steady supply is turned off, the
LED will be On Amber
Steady.
Green Hardware diagnostics
On Steady passed.
Green Blinks amber while diag-
Blinking nostics are running.
Normal State Comments
Green Hardware diagnostics
On Steady passed.
Green Blinks amber while diag-
Blinking nostics are running.
). For
POST
MPX