Table of Contents
Advertisement
2.6. System Config Tasks Links
Initial Setup
System Setup
Upgrade
3EC 37770 AAAA TCZZA Ed. 02
Clicking this button pops up the Initial Setup page.
This page allows to:
•
Configure a user defined IP address and (sub)netmask for the SpeedTouch™610.
Enter the IP address and (sub)netmask in the appropriate fields. Click Apply to
apply the changes.
Clicking this button pops up the System Setup page.
For more information, see the Topic System Setup in section
on page
23.
Clicking this button pops up the Software- and Configuration Upgrade page.
This page allows to:
•
Upgrade the SpeedTouch™610 system software:
Therefore:
Step
Make sure no passive software resides on the SpeedTouch™610. If needed
1
click Remove Passive to remove the passive software version.
Browse to the location where the SpeedTouch™610 upgrade system software
2
resides. Therefore, click Browse.
Note: Upgrade software may be made available from your Service Provider.
Contact your Service Provider for more information.
2 The SpeedTouch™610 Web Interface
"2.2. Quick Tasks Links"
Action
39
Advertisement
Table of Contents
