Line Access - Line Pool Access Tab - Nortel BCM50 Installation Manual

Line Access - Line Pool Access tab

This tab allows you to add line pools to a telephone record.
Figure 11 Line Access - Line Pool Access tab
These shared pools of lines allow many users to use fewer lines for connections where dedicated
lines are not practical or not desirable. If all lines in the pool are taken, the user receives a busy
signal.
Some trunks, such as PRI and VoIP need to be put into line pools. For incoming calls, these lines
use target lines to access the system telephones. For outgoing calls, the line pools are assigned to
the telephones that will be calling out over these trunks.
All lines except PRI lines are configured in line pools A to O. PRI lines can be configured into line
pools BLOC-A to BLOC-F.
The following table describes the fields on this screen.
Table 12 Line Pool Access fields
Attribute
Line Pool
Actions
Add
Delete
Values Description
<read-only>
outgoing call access you want for the telephone.
1. On the System DNs table (Line access tab), choose the DN record where you want to
add line pools.
2. Under the Line Pools table, click the Add button.
3. Enter a line pool in the dialog box.
4. Click OK on the dialog box to save the line pool to the list.
1. On the System DNs table (Line access tab), choose the DN record where you want to
delete line pools.
2. On the Line Pools table, select a line pool you want to delete.
3. Click the Delete button.
4. Click OK on the dialog box.
This is a list of available line pools. Pick the ones that provide the
49
DN records parameters