Configuring The Bcm50 System; Configuring The Initial Parameters - Nortel BCM50 Installation And Configuration Manual

Chapter 3

Configuring the BCM50 system

This section provides information on configuring the basic BCM50 parameters. You can configure
more advanced parameters using Element Manager or Telset Administration after the BCM50
system is operational.
For simplicity, the task of configuring the basic BCM50 parameters is divided into two parts:
•

"Configuring the initial parameters"

• "Configuring the startup parameters" on page 28
Configuring the initial parameters
The initial parameters are the required parameters that can be configured using Telset
Administration, Element Manager, or the Startup Profile. See
parameters.
Table 7 Initial parameters (Sheet 1 of 2)
Parameters
Keycode
IP address:
• Obtain dynamically?
• IP address
• Subnet mask
• Default gateway
Modem:
• Enable/disable modem
System:
• Region
Telephony startup:
• Template
• Start DN
Telset Administration
Feature 9*8 > Keycode
Feature 9*8 > IP Address
Feature 9*8 > Modem
Feature **PROFILE
Feature **STARTUP
Table 7
Element Manager
Configuration > System >
Keycodes
Configuration > System >
IP Subsystem
Configuration >
Administrator Access >
Modem
Administration > Utilities >
Reset > Cold Reset
Telephony Services
Administration > Utilities >
Reset > Cold Reset
Telephony Services
BCM50 First Time Installation and Configuration Guide
for a list of the initial
Startup Profile
Keycodes
IP Address
Modem
System
Telephony Startup
27