Display Saved-Configuration; Display This - 3Com 5500G-EI Command Reference Manual

Configuration File Management Commands 413
To view the pre-positive and post-positive configuration information, enter the
following:
<SW5500>display current-configuration configuration
display Syntax
saved-configuration
display saved-configuration [ unit unit-id ]
View
All views
Parameter
Specify the Unit ID of switch.
unit unit-id :
Description
Use the command to view the configuration files

display saved-configuration

in the flash memory of the Switch.
If the Switch works abnormally after power on, execute the
display
command to view the startup configuration of the Switch.
saved-configuration
Related commands: , ,
save reset saved-configuration display
.
current-configuration
Example
To display configuration files in flash memory of the Switch, enter the following:
<SW5500>display saved-configuration

display this

Syntax
display this
View
All views
Parameter
None
Description
Use the command, to display the configuration of the current view.
display this
If you need to authenticate whether the configurations are correct, after you have
finished a set of configurations under a view to use the command
display this
to view the parameters.
Some effective parameters are not displayed if they are the same as the default
ones. Some ineffective parameters that were configured by the user, are not
displayed either.
Associated configuration of the interface is displayed when executing the
command in different interface views, related configuration of the protocol view is
displayed when excecuting this command in different protocol views, and all the