Description Of Edit Operand Fields - Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual

Mathematical Table

7-9-6 Description of Edit Operand Fields

310
S Numerical Operator (Addition, Subtraction, Multiplication, Division (result will
have the quotient only) and Modulo)
S Boolean Operator(AND, OR & XOR)
S Bitwise Operator (&: bitwise AND, |: bitwise OR and ^: bitwise XOR)
S Comparison Operator (<, > and =)
This dialog box will be obtained by clicking 'any of the enable Operand' buttons.
This will be used to specify the operand.
Operand Type
This combo box will specify the type of operand. Default is 'None' and OK button
will remain disabled unless some other selection is made. The following choices
are available for the combo box:
PLC Address
This is almost like the address dialog box. There is an extra field: Storage Type.
Storage Type
Specify the type of the storage type (BCD/BIN).
Numeral Table Entry
Numeral Table Entry
Specifies numeral table entry number. Numeral table entry can be specified in
this edit box using corresponding table button
Section 7-9
.