Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 125

Common Operation
Reference: S If multiple data creation screens are displayed, an element can be moved over
Cutting and pasting elements
112
(1) Select an element.
(2) Select [Edit] (menu bar), then select [Copy].
This operation is also possible using the pop-up edit menu; display the pop-
up edit menu by right clicking the mouse on the element and select [Copy] in
the menu.
(3) Select [Edit] (menu bar), then select [Paste].
This operation is also possible using the pop-up edit menu; display the pop-
up edit menu by right clicking the mouse and select [Paste] in the menu.
to another data creation screen by dragging it.
If Ctrl key is being pressed while dragging, an element will be copied instead of
being moved.
S If two Support Tools are started up, copy, cut, paste and drag & drop operations
can be performed between Support Tools.
For details, refer to 3-3-6 Importing Components from Different Screen Data
File (Starting Up the Second Support Tool).
The procedure for cutting an arranged element to the clip board then pasting it at
another position in the screen is shown below.
The attributes set to the cut source element are also copied.
The pasted element is displayed at the upper left section of the screen.
The element cut to the clip board can be used for pasting as many times as de-
sired until another element is copied or cut. Pasting a cut element to another
screen is also possible.
(1) Select an element.
Selection of multiple elements collectively is possible.
(2) Select [Edit] (menu bar), then select [Cut].
This operation is also possible using the pop-up edit menu; display the pop-
up edit menu by right clicking the mouse on the element and select [Cut] in
the menu.
(3) Select [Edit] (menu bar), then select [Paste].
Section 6-1
Copied element is pasted at the
upper left section of the screen.