Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 141

Common Operation
Direct input of PLC address
128
In the dialog, PLC address can be set easily by selecting from the available
areas.
Example: Numeral table
(PLC Vendor : OMRON)
Channel (Word)
Select the type of word to be referred to from the list box.
Address
Input the address of word to be referred to.
Bit
Input the bit position in the word to be referred to.
It is possible to input PC (PLC) address, for example D00001, directly into the
address input field. You can input addresses easily when you know which area is
available.
When inputting PLC addresses, input a word address and a bit number without a
blank following a character that indicates area type. However, in case of numeral
table or string table, specification of bit number is not needed.
When you do not specify PLC address, input "- -" into the input field.
Input methods varies according to the PLC Vendor setting as listed below. Only
input method is described here. For details on specification method of PLC ad-
dress for PLC other than OMRON, refer to PC Connection Operation Manual
(V042-E1-j).
PLC Vendor: OMRON
Possible areas and characters that indicate area type are as follows:
Character
None Common I/O Area
H HR Area
A AR Area
L LR Area
T Timers
C Counters
D Data Memory Area
E EM Current Bank
E0 EM Bank 0 (CS/CJ–series PLCs)
E1 EM Bank 1 (CS/CJ–series PLCs)
E2 EM Bank 2 (CS/CJ–series PLCs)
E3 EM Bank 3 (CS/CJ–series PLCs)
E4 EM Bank 4 (CS/CJ–series PLCs)
Example: Touch switch
(PLC Vendor : OMRON)
Area Type
Section 6-1
Word Bit
f f
f f
f f
f f
f
f
f f
f f
f f
1 1
f f
1 1
f f
1 1
f f
1 1
f f
1 1