Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 284

Common Operation
How addresses are changed
Operation procedure
Change to – Channel (Word)
Specify the word type and start address after the change.
Addresses are changed within the number of specified points from the start ad-
dress (number of points from "Start Range" to "End Range").
Change Comment
Specify whether or not the same I/O comment appended to an address before
the change is appended to the address after the change.
To append the same I/O comment, click on the check box to display a check mark
in it.
Batch address change processing starts when you click on this button.
In the operation for changing addresses in bit units, processing is executed as-
suming that bit 15 of a word is immediately followed by bit 0 of the next word.
Addresses are changed as shown below according to the set search range and
the address after the change.
Example: Bit memory table
Address and Bit set
for [End Range]
CIO area Word 1
Bit 15
15
Bit
HR area
Before change
0000010
0000012
0000100
0000110
0000115
(1) Click on
(2) Select the type of word before the change in the [Channel] box.
(3) Specify the range of the change by setting addresses at the [Start Range]
and [End Range] boxes.
(4) Specify the word and the address after the change in the corresponding
boxes in the [Change To] area.
Address and Bit set
for [Start Range]
CIO area
0 15 10
0 15
Word 11 HR area
[Change To] – [Address]
(start address after the change)
.
Section 7-1
Word 0
0
0
Word 10
After change
H0001000
H0001002
H0001006
H0001100
H0001105
271