Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 315

I/O Comment Table
Reference: S For SYSMAC Support Soft, SYSMAC CPT, priority of word types to be im-
302
(3) When the operation is finished, the message "Import of I/O Comments, op-
eration completed" is displayed. Then, click the
When an I/O comment import was aborted or could not be done because of
error, the message "Failed to import I/O comment" is displayed, then click
the Button. In this case, the contents of I/O comment table in
Support Tool remain unchanged.
If this message box is displayed, check the following points.
S Is this a program file for OMRON C-series PLC?
S Is the extension .SP1 (SSS program file format)?
In case OMRON SYSMAC CPT is used, store (export) the ladder program in
SSS program (*.SP1) format and then use this file to import I/O comment.
ported is given below. CIO has the highest priority.
(With comments of more than 3000 entries, D will be cut first.)
CIO (Bit)
L (Bit)
H (Bit)
TIM/CNT
A (Bit)
CIO (Word)
L (Word)
H (Word)
A (Word)
D (Word)
The I/O comments table displays comments in numerical/alphabetical order.
Using CX-Programmer
Use the following procedure to import the I/O comments from the CX-Program-
mer.
(1) Copy the symbol table in the CX-Programmer and paste it into Excel.
(2) In Excel, delete columns 2 and 5 to that the names, addresses, and com-
ments are lined up across the sheet.
Section 7-7
Button.
Delete columns 2 and 5.