Sending (Downloading) The Data - Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual

Sending (Downloading) the Data

11-3 Sending (Downloading) the Data

Item
COM Port Specify the RS-232C port to be used.
Specify either COM1, COM2, COM3, or COM4.
Baud Rate Set the data communication rate.
If "38.4 Kbps (High)" is set, high-speed data communica-
tion is possible. (Not available for NT11S/NT11.)
It is recommended to specify "9.6 Kbps (Standard)" to en-
sure error-free communication if a communication error
occurs due to an inadequate communication environment.
Data communication at the "9.6 Kbps (Standard)" setting
will take about twice the time required in the "38.4 Kbps
(High)" setting.
If the PT is set to the NT21, even faster communications
are possible by selected 115 Kbps.
Verify Select this item by setting a check mark in the check box if
you want to check the communication data at the same
time it is transmitted. Please note that this setting is al-
lowed only for NT11S/NT11, NT20, NT20S and NT600S.
(3) After completing the setting for all items, click on
To send (download) the data created or edited by the Support Tool to a PT, follow
the steps shown below.
The type of data that can be sent is indicated in the table below.
Data Type
Application (in file units)
Screen
Direct Access Information
Description
Description
All data is sent in batch.
Data is sent in units of a screen.
It is possible to send the data of several
screens at a time.
When sending the data of a parent screen, you
can specify whether or not the data of the child
screens should be sent with the parent screen
data.
NT20, NT20S and NT600S:
Information on the PC (PLC) addresses allo-
cated to the PT status control area, PT status
notify area, numeral/character string memory
table (string table), etc.
NT21:
Information on the PC (PLC) addresses allo-
cated to PT status control area, PT status
notify area, and window control area.
NT31, NT31C, NT631, and NT631C:
Information of the PC (PLC) addresses allo-
cated to PT status control area, PT status
notify area and window control area (models
with "-V1" and above).
Section 11-3
.
431