Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 496

System Installer Operation
Installing the System Program
488
Extension
.20
.20M
.21
.31
.31C
.31G
.31D
.631
.63C
.63D
.11S
.11
30
30C
62S
62C
S Specifying the System and Extension
These selection items will be displayed if the NT20 is selected for the PT mod-
el.
For the NT20, the system program will be divided into the following two items:
System: Program itself
Extension: Resource data for each display language
Select which of the two will be transferred.
:
The system program is installed when this button is clicked.
The procedure for installing the system program is shown below.
(1) Specify the PT model for which the system program is installed for [PT Mod-
el] in the main window.
(2) Specify the system program to be installed by setting the information at
[Drive], [Look in], and [System File(s)] in the main window.
(3) Specify the RS-232C port used for the communications with the PT for [Com
Port].
(4) Make the PT ready for installation of the system program.
The operation required at the PT varies depending on the PT model. Basi-
cally, execute the processing for deleting the system program, then that for
setting the PT in the state in which it waits for the reception of the system
program. For details, refer to the manual for your PT.
(5) Click on
PT Model
NT20 (System)
NT20 (Extended)
NT21
NT31
NT31C
NT31-V3
NT31C-V3
NT631
NT631C
NT631C-V3
NT11S
NT11
NT30
NT30C
NT620S
NT620C/NT625C
in the main window.
Appendix B