Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 239

Graphs
Guidance
226
0%
Table Entry: Specify this item if a 0% value is set by a numeral memory table
entry; set the table entry number of the numeral memory table.
Value: Specify this item if a 0% value is set by a constant; set the value to
be taken for a 0% value.
–100%
Table Entry: Specify this item if a –100% value is set by a numeral memory
table entry; set the table entry number of the numeral memory
table.
Value: Specify this item if a –100% value is set by a constant; set the val-
ue to be taken for a –100% value.
Note that specification for –100% is valid only when [Display Sign] is selected.
Setting of 0% and –100% is not possible with NT20S and NT600S.
S The following types of bar graph element are provided.
0% to 100% display
Direction: Right
Direction: Left Direction: Up Direction: Down
–100% to 100% display
Direction: Right
Direction: Left Direction: Up Direction: Down
S Which of [0 to 100%] and [–100 to 100%] bar graphs is displayed should be
selected with the setting for [Display Sign] in the general attributes.
Check mark set:
Check mark not set: 0 to 100% display
S In the default setting, a percentage value is displayed.
Whether or not a percentage value is displayed can be set with the [Display %]
property.
Check mark set:
Check mark not set: A percentage value is not displayed.
S If the setting is for a percentage value to be displayed, the size and display
position of the value can be modified using the element edit function in the
manner shown below. (For detail of the element edit function, refer to page
110.)
–100 to 100% display
A percentage value is displayed.
Section 6-9