Fixed Display
Operation procedure
Terminology
Property setting
Guidance
Circles can be used with all models except for NT11S/NT11.
(1) A circle is drawn. The radius of a circle can be changed.
Selection using the menu bar:
Selection using the drawing toolbar:
General
Position
Center point:
Indicates the position of the center of a circle.
Size:
Indicates the radius of a circle.
Attribute:
Specify the display attribute. (Setting is not possible with NT20,
NT20S and NT600S) Standard, Inverse, Flash, Inverse Flash
Color
Foreground:
Specify the line color.
(Can only be set for PTs with color display.)
White, black, blue, red, magenta, green, cyan, yellow
S A circle element can be modified in the manner shown below.
A circle can be modified by dragging a green J mark (handle).
[Objects]
[Fixed Display]
Center point
Section
6-2
[Circle]
141