Image Editor
Changing the image data size
Quitting the image editor
The image data size can be changed in either of the following two ways.
S Changing the size by property setting
S Changing the size to the range specifying frame size
S Changing the size by property setting
Change the setting for [Size] in the image editor property settings to change the
size of the image data.
The image data size is changed according to the new setting; the reference
point of the size change is at the upper left corner of the present size.
If the size is reduced, part of the created graphic may be cut.
S Changing the size to the range specifying frame size
The size of the image data can be changed to fit the size of the specified range
specifying frame.
Select [Edit] in the menu bar, then select [Clip].
You can quit the image editor in any of the three ways described below.
S Clicking the
Button at the upper right corner of the image editor.
S Selecting [Close] from the control menu box of the image editor.
S Double clicking the control menu box of the image editor.
Control menu box
Section
8-1
333