Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 60

Operation of Screen Data (Application) File
PT Model
Ver.1.01
NT31 "NT31"
NT31C "NT31C"
NT631 "NT631"
NT631C "NT631C"
Reference: To check the system program version installed in a PT, display the following
46
S Menu Bar
S Menu Bar
The PT configuration dialog box has a variety of setting items provided in three
pages.
S PT Type page
S System page
S Control/Notify Area page
S PT Type page
The PT Type page is displayed when you click on the [PT Type] tab.
The PT Type page is used to set the hardware configuration of the PT to be
connected.
PT Model
Specify the type of PT to be connected. When you are using the NT31, NT31C,
NT631 or NT631C, refer to the table below to select the correct model according
to the system program being installed.
Ver.2.0
"NT31-V1" "NT31-V1(System Ver.2.1)"
"NT31C-V1" "NT31C-V1(System Ver.2.1)"
"NT631-V1" "NT631-V1(System Ver.2.1)"
"NT631C-V1" "NT631C-V1(System Ver.2.1)"
screens:
S Version display at the upper right position of PT system menu
S PT system menu ! Expansion mode ! Version display
The the NT20, either "NT20S" screen data (compatible with previous NT20S) or
"NT20" screen data (with expanded CS/CJ-series PLC data access) can be
used.
The following PT Models are also available:
[File] [New] (creating new application)
[Tools] [PT Configuration] (for modifying)
System Program
Ver.2.1
"NT31-V2/V3 (System Ver. 3.1)"
"NT31C-V2/V3 (System Ver. 3.1)"
"NT631-V2 (System Ver. 3.1)"
"NT631C-V2/V3 (System Ver. 3.1)"
Section 3-3
Ver.3.1 or Ver.4.0