Omron E5AN-H User Manual page 62

Using the Support Software Port
• Digital Controller Connection Method
Personal computer's USB port
E5EN-H
Communications port
for Support Software
Bottom view of E5EN-H
Note Hold the connector when inserting or disconnecting the Cable.
3. Install the driver.
Install the driver to enable the Cable to be used with the personal comput-
er.
• Installation
When the Cable is connected with the personal computer, the OS detects
the product as a new device. At this time, install the driver using the instal-
lation wizard. For details on installation methods, refer to the user's man-
ual for the E58-CIFQ1 USB-Serial Conversion Cable.
4. Setting Setup Tool Communications Conditions
Set the communications port (COM port) number to be used for the CX-
Thermo Setup Tool to the COM port number assigned to the USB-Serial
Conversion Cable.
Refer to the E58-CIFQ1 USB-Serial Conversion Cable Instruction Manual
and Setup Manual for details on how to check the COM port assigned to
the USB-Serial Conversion Cable.
The communications conditions for Setup Tool COM ports are fixed as
shown in the table below. Set the communications conditions for the CX-
Thermo Setup Tool according to the following table.
Parameter
Communications Unit No.
Communications baud rate
Communications data length
Communications stop bits
Communications parity
E58-CIFQ1
Bottom view of E5CN-H
Communications port
for Support Software
Set value
01
38.4 (kbps)
7 (bits)
2 (bits)
Even
Section 2-3
E5CN-H
Communications port
for Support Software
E5AN-H
Bottom view of E5AN-H
41