Omron E5AN-H User Manual page 260

Initial Setting Level
Setting
Note
See
See
clfl
Closed/Floating
Function
Setting
• Default: Event Input Assignment 1:
Event Input Assignment 2:
Event Input Assignment 3:
Event Input Assignment 4:
Setting
none
stop
manu
prst
drs
rsp
at-2
at-1
wtpt
cmwt
lat
(1) PRST (Program Start) can be set even when the Program Pattern param-
eter is set to OFF, but the function will be disabled.
(2) This can be selected only for models that support the remote SP function.
(3) This setting will be ignored for heating/cooling control or for position-pro-
portional (floating) control.
(4) This can be selected only for models that support communications. Also,
when a work bit is selected as event input data, communications writing
enable/disable cannot be selected.
■ Related Parameter
Bank Numbers Used (initial setting level): Page 237
• This parameter is used to select the control method for position-propor-
tional control.
Setting range
flot: Floating
clos: Closed
none
stop
(For Controllers supporting
event inputs 3 and 4, the default
is none.)
none
none
Function
None
RUN/STOP
Auto/Manual
Program start (See note 1.)
Invert Direct/Reverse Opera-
tion
SP Mode Switch (See note 2.)
100% AT Execute/Cancel
40% AT Execute/Cancel (See
note 3.)
Setting Change Enable/Dis-
able (See note 4.)
Communications Write
Enable/Disable
Alarm Latch Cancel
Position-proportional control must be
supported and there must be a
potentiometer input.
Default
flot
Section 5-9
239