Omron E5AN-H User Manual page 194

Protect Level
wtpt
Setting Change Protect
Function
Setting
pfpt
PF Key Protect
Function
Setting
pmsk
Parameter Mask Enable
Function
Setting
Note
This parameter specifies the range of data to be protected. The shaded cell
indicates the default.
■ Change Setting Protect
Changes to settings using key operations are restricted.
When enabling and disabling of setting changes by event inputs assignment 1
to 4 is selected, this parameter is not displayed.
Set value
OFF Settings can be changed using key operations.
ON Settings cannot be changed using key operations. (The protect level
settings, however, can be changed.)
• The all protect indication (
■ PF Key Protect
This parameter enables and disables PF Key operation (E5AN/EN-H only).
Set value
OFF PF Key enabled
ON PF Key disabled (Operation as a function key is prohibited.)
• The shaded cell indicates the default.
• This parameter turns the parameter mask function ON and OFF.
Setting range
on: Enabled, off: Disabled
A parameter mask can be used to hide the displays of parameters that are not
needed. The parameter mask function is provided by the Setup Tool.
Setup Tool: CX-Thermo (EST2-2C-MV4)
The Event Input Assignment 1 to 4
parameters must not be set to "set-
ting change enable/disable."
Description
) will light when setting is ON.
The Controller must have a PF Key
(E5AN/EN-H).
Description
This parameter is displayed only
when a parameter mask has been
set from the Setup Tool.
Default
on
Section 5-2
173