Omron E5AN-H User Manual page 282

Advanced Function Setting Level
out1
Control Output 1 Assignment
Function
Setting
Note
See
See
• This parameter sets the function to be assigned to control output 1.
None: No function is assigned to control output 1.
o:
Heating control output is output.
c-o:
Cooling control output is output. (See note 1.)
alm1: Alarm 1 is output. (See note 2.)
alm2: Alarm 2 is output. (See note 2.)
alm3: Alarm 3 is output. (See note 2.)
p.end: Program end is output. (See notes 2 and 3.)
ralm: Control output ON/OFF count alarm (See note 2.)
wr1:
Work bit 1 (See notes 2 and 4.)
wr2:
Work bit 2 (See notes 2 and 4.)
wr3:
Work bit 3 (See notes 2 and 4.)
wr4:
Work bit 4 (See notes 2 and 4.)
wr5:
Work bit 5 (See notes 2 and 4.)
wr6:
Work bit 6 (See notes 2 and 4.)
wr7:
Work bit 7 (See notes 2 and 4.)
wr8:
Work bit 8 (See notes 2 and 4.)
(1) If c-o is assigned for standard control, a value equivalent to 0% is output.
(2) Can be selected for a relay output, voltage output (for driving SSR), or
SSR output only.
(3) Can be selected when the Program Pattern parameter is set to OFF, but
the function will be disabled.
(4) WR1 to WR8 are not displayed when the logic operation function is not
used.
■ Related Parameters
Standard or heating/cooling: Page 228, Program pattern: Page 229, Transfer
output type: Page 235 (initial setting level)
There must a transfer output, or if
there is no transfer output, control
output 1 must not be a linear output
or if it is a linear output, the transfer
output type must be set to OFF.
Setting range
Section 5-10
Default
o
261