Omron E5AN-H User Manual page 257

Initial Setting Level
tr-h
Transfer Output Upper Limit
tr-l
Transfer Output Lower Limit
Function
Transfer output
type
Setting
Set point (See
note 1.)
Set point during
SP ramp
PV
MV monitor
(heating) (See
note 2.)
MV monitor
(cooling) (See
note 3.)
Valve opening
(See note 4.)
Note
See
See
o1-t
Linear Current Output
236
• This parameter sets the upper and lower limit values of transfer outputs.
Setting range
SP lower limit to SP upper limit
SP lower limit to SP upper limit
Temperature Input setting range lower limit
to input setting range upper
limit
Analog Analog scaling lower limit to
analog scaling upper limit
−5.0 to 105.0
Standard
Heating/ 0.0 to 105.0
cooling
0.0 to 105.0
−10.0 to 110.0
Position-pro-
portional
(1) If the set point is selected, the remote SP will be output as long as the
Remote SP Mode is selected in the SP Mode parameter.
(2) This setting will be ignored for position-proportional model.
(3) This setting will be ignored for standard control or position-proportional
control.
(4) This parameter will be displayed only when the is a potentiometer input
for a position-proportional model.
■ Related Parameter
Transfer output type (initial setting level): Page 235
This parameter selects the output type for linear current outputs.
• When control output 1 or control output 2 is a current output, select either
4 to 20 mA or 0 to 20 mA as the output type.
A transfer output or linear voltage
output must be supported.
The Transfer Output Type parameter
must not be set to OFF.
Default
Transfer Transfer
output lower output upper
limit limit
SP lower limit SP upper limit
Input setting Input setting
range lower range upper
limit limit
Scaling lower Scaling upper
limit limit
0.0 100.0
The E5CN-H must be used, and the
control output must be a current out-
put.
Section 5-9
Unit
EU
%