Omron E5AN-H User Manual page 350

Note (1) The parameters in the current PID set will be accessed.
(2) Displayed for ON/OFF control.
(3) The setting range depends on whether control output 1 is a linear output (relay output, current out-
put, or linear voltage output) or an ON/OFF output (voltage output (for driving SSR) or SSR output.
(4) The setting range depends on whether control output 2 is a linear output (relay output, current out-
put, or linear voltage output) or an ON/OFF output (voltage output (for driving SSR) or SSR output.
(5) This setting is ignored if the Program Pattern parameter is OFF.
(6) WR1 to WR8 are not displayed if logic operations are not used.
Protect Level
Parameters Characters
Move to Protect level pmov
oapt
Operation/Adjust-
ment Protect
icpt
Initial Setting/Com-
munications Protect
wtpt
Setting Change Pro-
tect
pfpt
PF Key Protect
pmsk
Parameter Mask
Enable
prlp
Password to Move to
Protect Level
Communications Setting Level
Parameters Characters
psel
Protocol Setting
u-no
Communications
Unit No.
bps
Communications
Baud Rate
len
Communications
Data Length
sbit
Communications
Stop Bits
prty
Communications
Parity
sdwt
Send Data Wait
Time
Note (1) When setting CWF, either CompoWay/F or SYSWAY can be used as the communications protocol.
(CompoWay/F and SYSWAY are automatically identified by the command frames.)
Setting (monitor) value
−1999 to 9,999
0 to 3
0 to 2
OFF, ON
OFF, ON
OFF, ON
−1999 to 9,999
Setting (monitor) value
CompoWay/F (SYSWAY),
Modbus (See note 1.)
0 to 99
1.2, 2.4, 4.8, 9.6, 19.2, 38.4,
or 57.6
7, 8
1, 2
None, Even, Odd
0 to 99
Display Default
0
0
0
off, on
OFF
off, on
OFF
off, on
ON
0
Display Default
cwf, mod
Compo-
Way/F
(SYSWAY)
1
1.2, 2.4,
9.6
4.8, 9.6,
19.2, 38.4,
57.6
7
2
none,
Even
even, odd
20
Appendix
Unit Set value
None
None
None
None
None
None
None
Unit Set value
None
None
kbps
Bit
Bit
None
ms
329