Omron E5AN-H User Manual page 48

Installation
1,2,3... 1. While lifting the hooks securing the PCB on the front panel, remove the
PCB to which the sockets are attached.
Hooks securing PCB
2. Set the Output Unit for control output 1 in the OUT1 socket. Set the Output
Unit for control output 2 in the OUT2 socket.
OUT1
OUT2
3. For the E5AN-H, use the enclosed clamps to secure the Output Units. Do
not use clamps for the E5EN-H.
Clamps
4. Set the PCB back in its original location, and make sure that the hooks se-
curing the PCB are firmly in place.
Confirm that the hooks
securing the PCB are
firmly in place on the top
and bottom.
E5AN-H
Confirm that the hooks
securing the PCB are
firmly in place on the top
and bottom.
E5AN-H
Section 2-1
Hooks securing PCB
E5EN-H
E5EN-H
27