Conventions Used In This Section; Meanings Of Icons Used In This Section; About Related Parameter Displays; The Order Of Parameters In This Section - Omron E5AN-H User Manual

Conventions Used in this Section

5-1

Conventions Used in this Section

5-1-1

Meanings of Icons Used in this Section

Function
Setting
Monitor
Operation
See
See
5-1-2

About Related Parameter Displays

at
AT Execute/Cancel
Displayed symbol
5-1-3

The Order of Parameters in This Section

5-1-4

Alarms

170
Describes the functions of the parameter.
Describes the setting range and default of the parameter.
Used to indicate parameters used only for monitoring.
Describes the parameter settings, such as those for Operation Commands,
and procedures.
Used to indicate information on descriptions in which the parameter is used or
the names of related parameters.
Parameters are displayed only when the conditions for use given on the right
of the parameter heading are satisfied. Protected parameters are not dis-
played regardless of the conditions for use, but the settings of these parame-
ters are still valid.
Parameter name
Parameters are described level by level.
The first page of each level describes the parameters in the level and the pro-
cedure to switch between parameters.
It will be specified in this section when alarms are set for the Control Output 1
or 2 Assignment parameters, or for the Auxiliary Output 1 or 3 Assignment
parameters. For example, when alarm 1 is set for the Control Output 1 Assign-
ment parameter, it will be specified that alarm 1 is assigned.
Assigning a work bit to either control output 1 or 2 or to auxiliary output 1 to 3
is also considered to be the same as assigning an alarm. For example, if work
bit 1 is set for the Auxiliary Output 1 Assignment parameter, then alarms 1 to 3
have been assigned.
The E5CN-H must be in operation,
and control must be 2-PID control.
Conditions for use
Section 5-1