Setting The Pf Key; Pf Setting (Function Key) - Omron E5AN-H User Manual

Setting the PF Key

4-20 Setting the PF Key

4-20-1 PF Setting (Function Key)

PF Setting
pf
a-m
OFF
RUN
STOP
R-S
AT-2
AT-1
LAT
A-M
PFDP
BANK
Note
Monitor/Setting Item
Monitor/Setting Item 1
pfd1
Item 5
pfd5
1
0
148
• Pressing the PF Key for at least one second executes the operation set
in the PF Setting parameter (E5AN/EN-H only).
Set value Symbol
off
Disabled
run
RUN
stop
STOP
r-s
RUN/STOP reverse
operation
at-2
100% AT
Execute/Cancel
at-1
40% AT
Execute/Cancel
lat
Alarm Latch Cancel
a-m
Auto/Manual
pfdp
Monitor/Setting Item
bank
Bank Selection
(1) When AT cancel is specified, it means that AT is cancelled regardless of
whether the AT currently being executed is 100% AT or 40% AT.
(2) The setting of AT-1 will be ignored for heating/cooling control or for posi-
tion-proportional floating control.
(3) Alarms 1 to 3, heater burnout, HS alarms, and heater overcurrent latches
are cancelled.
(4) For details on auto/manual operations using the PF Key, refer to 4-13 Per-
forming Manual Control.
(5) Pressing the PF Key for at least one second executes operation accord-
ing to the set value. When the Monitor/Setting Item parameter is selected,
however, the display is changed in order from Monitor/Setting Item 1 to 5
each time the key is pressed.
(6) This function is enabled when PF Key Protect is OFF.
Setting the PF Setting parameter to the Monitor/Setting Item makes it possi-
ble to display monitor/setting items using the function key. The following
table shows the details of the settings. For setting (monitor) ranges, refer to
the applicable parameter.
Setting
Does not operate as a function key.
Specifies RUN status.
Specifies STOP status.
Specifies reversing the RUN/STOP opera-
tion status.
Specifies reversing the 100% AT Execute/
Cancel status. (See note 1.)
Specifies reversing the 40% AT Execute/
Cancel status. (See notes 1 and 2.)
Specifies canceling all alarm latches. (See
note 3.)
Specifies reversing the Auto/Manual status.
(See note 4.)
Specifies the monitor/setting item display.
Select the monitor setting item according to
the Monitor/Setting Item 1 to 5 parameters
(advanced function setting level).
Specifies switching to the bank number + 1.
Section 4-20
Function