Maintenance - EverFocus UNI IP Series User Manual

7.9.5 Maintenance

• Upgrading the Device
If the device is managed by the central management server and you want to upgrade the devices in
batch mode, it is recommended to perform the upgrade operation on the central server. For detailed
steps, see the user manual for the central management server.
1. Click Setup>System>Maintenance.
2. Under Software Upgrade, click Browse and select the correct upgrade file.
3. Click Upgrade and then confirm to start. The camera will restart automatically after the
upgrade is completed. Some devices support boot program upgrade. To upgrade, select
Upgrade Boot Program.
4. You may click Detect to check for new versions available to cloud upgrade.
NOTE!
You must use the correct upgrade file for you camera. Otherwise, unexpected results may

occur.
The upgrade file is a ZIP file and must include all the necessary files.

The boot program loads the operating system and then the system starts running. The

upgrade boot program function is disabled by default, and only the camera will be upgraded
to the latest version. If enabled, both the camera and the boot program are upgraded, and
the operating system of the following new versions can be booted properly and the camera
can be upgraded conveniently.
Ensure that the power supply is normal during upgrade. The device will restart after the

upgrade is completed.
• Restarting the System
1. Click Setup>System>Maintenance.
2. Under Device Restart, click Restart. The device will restart after you confirm the operation.
CAUTION!
Perform this operation with caution because restarting the system interrupts the ongoing
service.
UNI IP Series Network Cameras – H265, 2MP / 5MP
130