Table of Contents
Advertisement
7.5.1.3
Leave Area
Leave Area detection detects objects that leave a specified area, and triggers alarm when such an event
is detected.
NOTE!
1. Only some camera models support this function.
2. The supported alarm triggering and arming schedule may vary with camera model. Please
see the actual Web interface for details.
The camera takes the snapshot and sends the snapshot to the back end.
3.
Click Setup > Intelligent > Smart. Choose Leave Area, and then click
1.
Select Leave Area Detection.
2.
In Rule Settings area, click
3.
Drag the borders of the box to set the intended position and range.
4.
Set detection sensitivity for the camera to decide whether to report an alarm.
5.
Set the priority of detection to judge the trigger sequence when detection rules are triggered
at the same time.
6.
Set snapshot object type to judge whether to snap small pictures.
7.
Set object filter type and size, alarm-triggered actions and arming schedule as required.
8.
Set the alarm-triggered actions and arming schedule as required. For the detailed steps, see
the descriptions of alarm-triggered actions in 7.6.2 Common Alarm Configuration.
9.
Click Save.
UNI IP Series Network Cameras – H265, 2MP / 5MP
to add a new detection area. To delete a detection area, click
78
.
.
Advertisement
Table of Contents
