EverFocus UNI IP Series User Manual page 4

Do not install the camera near electric or magnetic fields.
Install the camera away from TV/radio transmitters, magnets, electric motors, transformers and audio
speakers since the electromagnetic fields generated from these devices may distort the video image
or otherwise interfere with camera operation.
Never disassemble the camera beyond the recommendations in this manual nor introduce
materials other than those recommended herein.
Improper disassembly or introduction of corrosive materials may result in equipment failure or other
damage.
Try to avoid facing the camera toward the sun.
In some circumstances, direct sunlight may cause permanent damage to the sensor and/or internal
circuits, as well as creating unbalanced illumination beyond the capability of the camera to
compensate.
1. Keep the power cord away from water and other liquids and never touch the power cord with
wet hands.
Touching a wet power cord with your hands or touching the power cord with wet hands may
result in electric shock.
2. Never install the camera in areas exposed to oil, gas or solvents.
Oil, gas or solvents may result in equipment failure, electric shock or, in extreme cases, fire.
3. Cleaning
For cameras with interchangeable lenses, do not touch the surface of the sensor directly with the
hands. Use lens tissue or a cotton tipped applicator and ethanol to clean the sensor and the
camera lens. Use a damp soft cloth to remove any dirt from the camera body. Please do not use
complex solvents, corrosive or abrasive agents for cleaning of any part of the camera.
4. Do not operate the camera beyond the specified temperature, humidity or power source ratings.
Use the camera at temperatures within -30°C ~ 55°C / -22°F ~ 131°F, and humidity
device is not rated as submersible. The input power source is 12VDC / PoE. Be sure to connect the
proper + / - polarity and voltage, as incorrect polarity or too high a voltage will likely cause the
camera to fail, and such damage is not covered by the warranty. The use of properly fused or Class
3 power limited type supplies is highly recommended.
5. Mounting
Use care in selecting a solid mounting surface which will support the weight of the camera plus
any wind, snow, ice or other loading, and securely attach the camera to the mounting surface
using screws and anchors which will properly support the camera. If necessary (e.g. when
mounting to drop ceilings) use a safety wire to provide additional support for the camera.
Precautions
95%; this
≤