Table of Contents
Advertisement
6.
Marking steps on a single marking page are as follows: Click Add, and then click on the left master camera
image. A small white frame appears at your clicking, and the area automatically zooms in (as shown below).
Click OK to confirm current marking point, or right-click to return to original image.
7.
Turn the slave camera to the position where the marking point is. Set the magnification of the slave camera
to the maximum, and make the cross in the center of the slave camera image coincide with the marking
point (the small white frame) in the master camera image. Click OK and Orient to link the marking points.
Click Cancel to cancel the linked marking points.
8.
Click a new position in the master camera image and repeat last step. You may need 5~12 marking points
depending on your needs. Click Finish and Next to turn to the next scene.
9.
Click Apply after you finish all the marking configurations. For multi-sensor cameras, click the button after
the marking configuration of four scenes is completed.
Master-Slave Linkage Use master-slave linkage to link a master device and a slave device. The master
device detects the target and the linked slave device tracks and captures the target.
UNI IP Series Network Cameras – H265, 2MP / 5MP
94
Advertisement
Table of Contents
