EverFocus UNI IP Series User Manual page 71

Set the parameters as required. The following table describes some major parameters.
Parameter
Select the correct exposure mode to achieve the desired exposure effect.
Automatic: The camera automatically adjusts exposure according to the environment.
Custom: The user sets exposure as needed.
Exposure
Indoor 50Hz:Reduce stripes by limiting shutter frequency.
Mode
Indoor 60Hz:Reduce stripes by limiting shutter frequency.
Manual: Finetune image quality by setting shutter, gain and iris manually.
Low Motion Blur: Control the minimum shutter to reduce motion blur in faces captured in
motion.
Shutter is used to control the light that comes into the lens. A fast shutter speed is ideal for
scenes in quick motion. A slow shutter speed is ideal for scenes that change slowly.
Note:
Shutter (s)
You can set a shutter speed when Exposure Mode is set to Manual or Shutter Priority.

If Slow Shutter is set to Off, the reciprocal of the shutter speed must be greater than the

frame rate.
Control image signals so that the camera outputs standard video signals according to the
light condition.
Gain (dB)
Note: You can set this parameter only when Exposure Mode is set to Manual or Gain
Priority.
Improves image brightness in low light conditions.
Slow Shutter
Note: You can set this parameter only when Exposure Mode is not set to Shutter Priority
and when Image Stabilizer is disabled.
Set the slowest shutter speed that the camera can use during exposure.
Slowest
Shutter
Note: You can set this parameter only when Slow Shutter is set to On.
UNI IP Series Network Cameras – H265, 2MP / 5MP
Description
64