Table of Contents
Advertisement
NOTE!
1. Only some camera models support this function.
2.
The supported linkage parameters, linkage mode and alarming schedule may vary with camera
model. Please see the actual Web interface for details.
1.
Click Setup > Intelligent > Smart. Choose Master-Slave Linkage, click
Linkage Parameter.
For some camera models, the page is displayed as follows.
2.
Select Enable Box-Dome Linkage.
3.
Track Mode: The linked slave camera tracks the target that triggers the set rules, until
timeout is up or the target disappears.
4.
Set master or slave IP address and HTTP port.
5.
Zoom coefficient: the greater the coefficient, the greater the zoom of the slave device.
6.
Select Continuously Track, and set tracking duration.
7.
Click Save.
8.
Click Mark Linkage.
UNI IP Series Network Cameras – H265, 2MP / 5MP
95
and then select
Advertisement
Table of Contents
