EverFocus UNI IP Series User Manual page 112

4. Set the alarm parameters.
Suppress Alarm(s): After an alarm is triggered, the same alarm will not be reported within the

set time.
Clear Alarm(s): After an alarm is triggered,

a. If the same alarm is not triggered within the set time, the alarm will be cleared and the
same alarm can be reported again.
b. If the same alarm is triggered within the set time, the alarm will not be cleared until the
suppress alarm time expires. Then the same alarm can be reported again.
5. Set actions to be triggered by motion detection alarm and the plan.
Grid Detection
Click Setup > Events > Motion Detection. Set Detection Mode to Grid.
1. Detection area(s) can be irregular on the grid.
2. Set detection sensitivity for the camera to decide whether to report a motion detection alarm
(alarm visible on compatible NVR).
3. Set alarm parameters.
Suppress Alarm(s): After an alarm is triggered, the same alarm will not be reported within the

set time.
Clear Alarm(s): After an alarm is triggered,

a. If the same alarm is not triggered within the set time, the alarm will be cleared and the
same alarm can be reported again.
UNI IP Series Network Cameras – H265, 2MP / 5MP
105