Table of Contents
Advertisement
Exit: Exit marking without saving.
Add: Add marking points.
Delete: Delete marking points.
Clear All: Clear all the marking points in current scene.
10. Marking steps on a single scene: Click Add, click on the left master camera image. A small
white frame appears at your clicking, and the area automatically zooms in (as shown below).
Adjust the position of the marking point on the enlarged area. Right click to return to original
image and select again. Click OK to confirm current marking point.
11. Turn the slave camera to the position where the marking point is. Set the zoom of the slave
camera to the maximum, and adjust the cross in the center of the slave camera image
coincide with the marking point (the small white frame) in the master camera image. Then
click Orient.
UNI IP Series Network Cameras – H265, 2MP / 5MP
97
Advertisement
Table of Contents
