EverFocus UNI IP Series User Manual page 133

2. Select PTZ Control from the Port Mode drop-down list. The following table describes some
major parameters.
Parameter
Set the PTZ protocol that the channel supports.
Note:
You can set this parameter only when Port Mode is set to PTZ Control.

PTZ Protocol
When PTZ Protocol is set to INTERNAL-PTZ, the camera can connect to the

external PTZ without using the serial port (serial port parameters are grayed
out). In this case, you only need to connect the zoom and focus interfaces of
the camera to the lens, and then you can operate the PTZ like an internal PTZ.
•
•
Note:
PTZ Mode
You can set this parameter only when Port Mode is set to PTZ Control.

When INTERNAL-PTZ is selected, this parameter is always set to Built-in PTZ

Priority, and it is unnecessary to connect the camera to an external PTZ
through the serial port. Control through the external PTZ is not effective even
when the camera has been connected to an external PTZ.
Set this parameter as required. Make sure PTZ control related interfaces are

correctly connected.
Set the address code for the PTZ.
Address
Note:
Code
You can set this parameter only when Port Mode is set to PTZ Control and PTZ
Protocol is not set toINTERNAL-PTZ.
Click Save.
Built-in PTZ Priority: When this option is selected, the camera first tries to
control the PTZ (for example, to zoom or focus) by itself instead of through
the external PTZ. For operations that the camera cannot accomplish by
itself, the camera uses the external PTZ.
External PTZ Priority: The camera first tries to control the PTZ through the
PTZ connected through the serial port.
UNI IP Series Network Cameras – H265, 2MP / 5MP
Description
126