•
Wiper Control
Set wiper parameters before you can control the wiper.
NOTE!
This function is not supported by some models. Please see the actual model for details.
1.
Click Setup>System>Ports & Devices, and then click the External Device tab.
2.
Set control mode for the wiper. The following table describes some major parameters.
Parameter
Serial Port
Alarm
Input/Output
7.9.4 Device Info
You can configure the basic info of your camera on the page.
The wiper is controlled by PELCO-D instructions; therefore, the PTZ protocol should be set
to PELCO-D. See PTZ Con for details.
Use alarm input and output to open or close the circuit and control the wiper.
UNI IP Series Network Cameras – H265, 2MP / 5MP
Description
129