Table of Contents
Advertisement
7.5.1.15
Master-Slave Linkage
NOTE!
1. Only some camera models support this function.
2. The supported linkage parameters, linkage mode and alarming schedule may vary with
camera model. Please see the actual Web interface for details.
Click Setup >Intelligent>Smart. Choose Master-Slave Linkage, click
Parameter tab.
For some camera models, the page is displayed as follows.
1.
Select Enable Box-Dome Linkage.
2.
Set master or slave IP address, HTTP port, and zoom coefficient.
3.
Click Save.
4.
Select Mark Linkage tab.
UNI IP Series Network Cameras – H265, 2MP / 5MP
92
and then select Linkage
Advertisement
Table of Contents
